gasraindustrial.blogg.se - Qnap surveillance station anonymous access

#QNAP SURVEILLANCE STATION ANONYMOUS ACCESS HOW TO#
#QNAP SURVEILLANCE STATION ANONYMOUS ACCESS SOFTWARE#
#QNAP SURVEILLANCE STATION ANONYMOUS ACCESS PC#

Open Qnapfinder, double Click to be sure that you can enter Qnap setup screen. Remove Disks Drives and start device without any HDD installed (Do not forget the order of your HDDs!)Ģ -You will hear a beep after pressing the power button, followed by 2 beeps in a few minutes later. If your System starts properly without HDD’s, but stuck at booting / Starting services at LCD panel, or Red/ Green light flashes continuesly, please follow this document ġ –Turn off the device. II – Stuck at Booting / Corrupted Configuration / Device Startup Errors / If everything is okey till this point, please go to next step to solve the problem. Important Note : Dont start installation at this point or you may lose all of your datas. If its sata cable problem, contact with Qnap Support team, or send device to Vendor. If its HDD problem, You can plug out infected HDD and continue. First check “How to understant Broken HDD” document. All of your HDD’s should be seen there with right size.

Wait around 10 second and press “details” on QNAPfinder. For example, if the IP of NAS is 169.254.100.100, you need to configure your PC’s ip to 169.254.100.101Ħ – While device is working, Plug all of your HDD’s to NAS with right order. The IP of the NAS unit should be on the same subnet of your PC. If problem continues, please contact with Qnap Supportĥ – Double Click the NAS to Start InitializationĪns : Failed to initialization. +Also press around 15 second to reset button at the back of the device.

#QNAP SURVEILLANCE STATION ANONYMOUS ACCESS SOFTWARE#

This kind of software may block the network access of Qnap finder. Please Disable firewall / antivirus software on the PC. Finder Should Find the NASĪns : Network Failure.

#QNAP SURVEILLANCE STATION ANONYMOUS ACCESS PC#

Please check “Firmware Reflash Document” to solve the problem.Ĥ – Connect the NAS to PC Directly and Run QNAP Finder. Sometimes taking off and plug in firmare flash back again solve problem, but ask this tou your vendor if this cause device out of warranty or not.ģ – After 2-4 minutes, The NAS Sound one or Three Long Beep (s)Īns : Firmware Problem. Contact to your Vender to send device for Repair. If it doestn work, send device back to Vendor.Ģ – Nas Sound a shot beep in a Few Seconds?Īns : Mainboard or Flash Error. Change electric cabe and check if problem still continue. Shut down Qnap Remove all HDD’s and Press ”Power” button.Īns : Powersupply, adaptor or Mainboard Problem. If you can use your Qnap witout problem, but now it becames unreachable, Please, follow the steps indicated below for the detection of the fault IV – Other Qnap Errors (Loading Driver, Mounting Volume)Ī – Error Opening Device / LCD Screen Booting Problem III – If You Can Login Qnap Interface, But Problem About Reaching Datas II – Cant Find Qnap with Qnapfinder / Stuck at Booting / Corrupted Configuration / Device Startup Errors /

What is RAID? Redundant Array of Independent Disks.

Warning : Re-Launch Process & The File System Is Not Clean.

Qnap Becomes Unreachable When I Plug Qnap to My Network.

Web-based Distributed Authoring and Versioning (WebDAV).

#QNAP SURVEILLANCE STATION ANONYMOUS ACCESS HOW TO#

What is Stress Test and How to Do Guide.

Qnap Benchmark, Lun Speed & Stability Test.